The tv came with no HDMI inputs with short circuit lines from the cpu to the input pins. Got another board from a group source and wrote these dumps on it and the tv worked well.
Считана с аппарата с неисправной матрицей (Типовуха для этой модели). Проверена перепрошивкой на подобном же аппарате 55 диагонали после замены main (пробит проц по 1,8 вольт) при установке платы с другого аппарата 50 диагонали и с матрицей AOU (Простая замена не проканала).
MAIN: 3 in 1 Kant-SU 50" BN96-46823A FLASH: W25Q40CLSIP W25Q80DVSIG EEPROM: 24C512 PANEL: CY-NN050HGNV6H Прошивка взята с рабочего аппарата после ремонта узла питания
I took this board off a tv that had a bad cpu i think , maybe the firmware isn't good but i think tv did boot up it had some other problems where the picture would freeze , i assumed is a bad cpu and changed the board. Use at your own risk..