BOOT_OK!decomp
_done
Board: MSTAR KAISERIN (CPU Speed 792 MHz)
DRAM: 128 X 128 MBytes
Flash is detected (0x0703, 0xEF, 0x40, 0x16)
MDrv_SERFLASH_GetInfo()
u32AccessWidth = 1
u32TotalSize = 4194304
u32SecNum = 64
u32SecSize = 65536
MBOOT UNFD-----------------------------------------------------------0711 16:07:
37
nand_unfd_init nand_pads_switch done
nand_unfd_init nand_clock_setting done
nand_unfd_init NC_ResetFCIE done
nand_unfd_init NC_ResetNandFlash done
nand_unfd_init NC_ReadID done
nand_unfd_init drvNAND_CHECK_FLASH_TYPE done
nand_unfd_init NC_PlatformInit done
nand_unfd_init NC_ConfigContext done
nand_unfd_init ECC_TYPE_4BIT
nand_unfd_init NC_Config done
>>>pagesize = 2048
0x00000000-0x07E00000 : "mtd=0"
UBI: attaching mtd0 to ubi0
UBI: physical eraseblock size: 131072 bytes (128 KiB)
UBI: logical eraseblock size: 126976 bytes
UBI: smallest flash I/O unit: 2048
UBI: VID header offset: 2048 (aligned 2048)
UBI: data offset: 4096
UBI: attached mtd0 to ubi0
UBI: MTD device name: "mtd=0"
UBI: MTD device size: 126 MiB
UBI: number of good PEBs: 1008
UBI: number of bad PEBs: 0
UBI: max. allowed volumes: 128
UBI: wear-leveling threshold: 4096
UBI: number of internal volumes: 1
UBI: number of user volumes: 5
UBI: available PEBs: 0
UBI: total number of reserved PEBs: 1008
UBI: number of PEBs reserved for bad PEB handling: 26
UBI: max/mean erase counter: 18/9
Check USB port[2]:
??? Waiting for Peripheral Connecting Fail...
usb init failed
Error, couldn't init Lowlevel part
Volume rootfs-2 found at volume id 3
read 0 bytes from volume 3 to 81000000(buf address)
Read [37838848] bytes
Volume kernel-2 found at volume id 1
read 0 bytes from volume 1 to 81000000(buf address)
Read [5332992] bytes
[auto_boot][2370], No immediate SW RESET.
Start 75F2000 End 769E000
Hi

Starting kernel ...

Hello UART