Boot-
PCB config=1, PCB ckeck=0
DRAM Channel A Calibration.
DRAM A Size = 1024 Mbytes.
DRAM Channel B Calibration.
DRAM B Size = 1024 Mbytes.
DRAM Channel C Calibration.
DRAM C Size = 512 Mbytes.
Boot
Start Pmain
0x0000a000
EMMC boot

CID:0xfc596441
:0x52077a60
:0x4a4e4234
:0x15010041
LZHS addr:0x00100040
LZHS size:0x0019cab8
LZHS checksum:0x00000095
LZHS size:0x0019cab8
store RSA & AES keys in DMX SRAM
LZHS begin
Boot
Start Lmain

MT5891 Boot Loader v0.9
SSUSB2: Set GPIO232 = 1.
Change pinmux register 0xf00286f0 (old: 0x 0, new: 0x 2000000)
Support network![MSDC] LOADER FAST READ EMMC!
==Loader emmc pinmux set result 0x1000a0, arbitor 0x20
Init config, cid = 0x15010041, dsc=0xfc596441,rca=0x52077a60,ocr=0x4a4e4234
[MSDC] 15010041:4a4e4234:52077a60:fc596441
[MSDC] id1:00414a4e id2:42345207
[MSDC] eMMC Name: UNKNOWN
---Set FIFO path and Init---
[MSDC] Set Bus Clock as HS25(MHz) Success!,src 3 ,mode 0, div 4
Use NEW AutoK idea ,ignore the old ett param
[MSDC] Set pad driving as 1 !
[eMMC2DRAM]enter into SDR50 Mode, max dtr 200000000
[MSDC] Set Bus Clock as HS0(MHz) Success!,src 0 ,mode 0, div 16
Use NEW AutoK idea ,ignore the old ett param
[MSDC] Set pad driving as 0 !
[MSDC] Set Bus Clock as HS50(MHz) Success!,src 3 ,mode 0, div 2
Use NEW AutoK idea ,ignore the old ett param
[MSDC] Set pad driving as 1 !
---Set FIFO path and Init---
[MSDC] unexpected interrupt: INT=0x8000
[MSDC] BasicDMA MsdcHandleDataTransfer: Failed to send/receive data (AccuVect 0x00000000 INTR 0x00008000). msdc_drv.c line 2606
[MSDC] card status 0x4 in error handle
Enter Loader Autok online tune.....speedMode 1
EMMC Tune AutoK READ sampel edge 0 --> 1
[MSDC] Data READ Tune Success
[MSDC] --ENTER RPMB--
verify dFrameResp.mac fail
Error: Fail to get RPMB Counter. ret = -8