|
Referance to message below
"Thanks to everyone for their participation, especially to comrade Lion18 , the issue was resolved quite trivially - by mirroring the pinout of the 24-pin cable in the layout (the corresponding checkbox in the interface), although according to the diagram, the connection of the programmer cable and the keyboard connector clearly goes one to one, that is: we install the 24-pin cable into the 26-pin connector one to one - 1 to 1 contact and put a checkmark to mirror, maybe it will be useful to someone, IT8586VG multicooker (bga), nm-a074 Lenovo Yoga 2 Pro board. Works fine the first time, without any ID and read timeout errors, just like in the videos from ifix on YouTube biggrin"
I am trying to recover one of my nm-a074 board, and try to grab EC from working board. I have followed all the steps, but ended with read timeout error all the time.
When connecting the cable on keyboard connector, I have omitted 3V and LED pins out of 26. I have started from the other end of the connector. Is this correct? I have tried with both checkmark and without check mark, but no use. I have connected ground of the board, screw hole to the programmer. Still no use. The board is from a working laptop. Can you please help me.... Thanks
| 
Файлы
Прошивки
Продажа
Литература
Статьи
Для просмотра сообщения Вы должны быть Участником форума. Для этого Вам необходимо 
Зарегистрировано всего