NOTICE: BL31: v1.3(release):3edeb02
NOTICE: BL31: Built : 16:43:54, Apr 14 2020
NOTICE: BL31: AXG secure boot!
NOTICE: BL31: BL33 decompress pass
OPS=0x43
[Image: axg_v1.1.3494-9ec8345 2020-04-17 18:16:39 jenkins@walle02-sh]
25 0c 43 00 c3 ac bf b3 9f 7a e1 5b 3a 07 57 99
bl30:axg ver: 9 mode: 0
bl30:axg thermal0
[0.015883 Inits done]
secure task start!
high task start!
low task start!
ERROR: Error initializing runtime service opteed_fast

U-Boot 2015.01 (Jan 13 2023 - 10:30:19)

DRAM: 256 MiB
Relocation Offset is: 0eeb0000
mmu cfg end: 0x20000000
mmu cfg end: 0x20000000
register usb cfg[0][1] = 000000000ff6e198
aml_i2c_init_port init regs for 2
NAND: get_sys_clk_rate_mtd() 292, clock setting 200!
bus cycle0: 6,timing: 7
NAND device id: 98 da 90 15 76 16
NAND device: Manufacturer ID: 0x98, Chip ID: 0x98 (Toshiba A revision
NAND 2Gib TC58NVG1S3HBAI4 )
get_sys_clk_rate_mtd() 292, clock setting 200!
m3_nand_adjust_timing() sys_clk_rate 200, bus_c 6, bus_t 7
oob_fill_cnt =32 oob_size =64, bch_bytes =14
ecc mode:6 ecc_page_num=2 eep_need_oobsize=16
plane_num=1 writesize=0x800 ecc.size=0x200 bch_mode=1
oob avail size 6
Creating 1 MTD partitions on "A revision NAND 2Gib TC58NVG1S3HBAI4 ":
0x000000000000-0x000000200000 : "bootloader"
A revision NAND 2Gib TC58NVG1S3HBAI4 initialized ok
get_sys_clk_rate_mtd() 292, clock setting 200!
bus cycle0: 6,timing: 7
NAND device id: 98 da 90 15 76 16
NAND device: Manufacturer ID: 0x98, Chip ID: 0x98 (Toshiba A revision
NAND 2Gib TC58NVG1S3HBAI4 )
get_sys_clk_rate_mtd() 292, clock setting 200!
m3_nand_adjust_timing() sys_clk_rate 200, bus_c 6, bus_t 7
oob_fill_cnt =32 oob_size =64, bch_bytes =14
ecc mode:6 ecc_page_num=2 eep_need_oobsize=16
PLANE change!
plane_num=1 writesize=0x800 ecc.size=0x200 bch_mode=1
aml_nand_init :oobmul=1,oobfree.length=8,
- oob_size=64
oob avail size 8
nbbt=20
nenv=24
nkey=32
ndtb=40
nddr=44
bbt_start=20 env_start=24 key_start=32 dtb_start=40 ddr_start=44
nbbt: info size=0x800 max_scan_blk=24, start_blk=20
nbbt : phy_blk_addr=20, ec=0, phy_page_addr=0, timestamp=1
nbbt free list:
blockN=21, ec=-1, dirty_flag=0
blockN=22, ec=-1, dirty_flag=0
blockN=23, ec=-1, dirty_flag=0
aml_nand_scan_rsv_info 1134: page_num=1
aml_nand_scan_rsv_info 1137
nbbt valid addr: 280000
aml_nand_bbt_check 1258 bbt is valid, reading.
aml_nand_read_rsv_info:446,read nbbt info to 280000
nenv: info size=0x10000 max_scan_blk=32, start_blk=24
nenv : phy_blk_addr=24, ec=0, phy_page_addr=0, timestamp=5
nenv free list:
blockN=25, ec=0, dirty_flag=1
blockN=26, ec=-1, dirty_flag=0
blockN=27, ec=-1, dirty_flag=0
blockN=28, ec=-1, dirty_flag=0
blockN=29, ec=-1, dirty_flag=0
blockN=30, ec=-1, dirty_flag=0
blockN=31, ec=-1, dirty_flag=0
aml_nand_scan_rsv_info 1134: page_num=32
aml_nand_scan_rsv_info 1137
nenv valid addr: 310000
nkey: info size=0x8000 max_scan_blk=40, start_blk=32
nkey : phy_blk_addr=33, ec=0, phy_page_addr=0, timestamp=2
nkey free list:
blockN=32, ec=0, dirty_flag=1
blockN=34, ec=-1, dirty_flag=0
blockN=35, ec=-1, dirty_flag=0
blockN=36, ec=-1, dirty_flag=0
blockN=37, ec=-1, dirty_flag=0
blockN=38, ec=-1, dirty_flag=0
blockN=39, ec=-1, dirty_flag=0
aml_nand_scan_rsv_info 1134: page_num=16
aml_nand_scan_rsv_info 1137
nkey valid addr: 430000
ndtb: info size=0x20000 max_scan_blk=44, start_blk=40
ndtb : phy_blk_addr=41, ec=0, phy_page_addr=0, timestamp=2
ndtb free list:
blockN=40, ec=-1, dirty_flag=0
blockN=42, ec=-1, dirty_flag=0
blockN=43, ec=-1, dirty_flag=0
aml_nand_scan_rsv_info 1134: page_num=64
aml_nand_scan_rsv_info 1137
ndtb valid addr: 520000
nddr: info size=0x800 max_scan_blk=46, start_blk=44
nddr : phy_blk_addr=-1, ec=0, phy_page_addr=0, timestamp=0
nddr free list:
blockN=44, ec=-1, dirty_flag=0
blockN=45, ec=-1, dirty_flag=0
aml_nand_scan_rsv_info 1134: page_num=1
nddr valid addr: fffffffffffe0000
aml_nand_rsv_info_check_except_bbt 1228 NO nddr exist
tpl: off 8388608, size 8388608
NAND bbt detect factory Bad block at c000000
NAND bbt detect factory Bad block at c020000
Creating 7 MTD partitions on "A revision NAND 2Gib TC58NVG1S3HBAI4 ":
0x000000800000-0x000001000000 : "tpl"
0x000001000000-0x000001200000 : "misc"
0x000001200000-0x000002200000 : "boot_a"
0x000002200000-0x000003200000 : "boot_b"
0x000003200000-0x000007200000 : "system_a"
0x000007200000-0x00000b200000 : "system_b"
0x00000b200000-0x000010000000 : "data"
NAND bbt detect factory Bad block at c000000
NAND bbt detect factory Bad block at c020000
A revision NAND 2Gib TC58NVG1S3HBAI4 initialized ok
MMC: aml_priv->desc_buf = 0x000000000deae760
aml_priv->desc_buf = 0x000000000deb0aa0
SDIO Port B: 0, SDIO Port C: 1
uboot env amlnf_env_read : ####
aml_nand_read_rsv_info:446,read nenv info to 310000
In: serial
Out: serial
Err: serial
aml log : internal sys error!
reboot_mode=cold_boot
Start read misc partition datas!
[burnup]Rd:Up sz 0x440 to align 0x1000
info->attemp_times = 12
info->active_slot = 0
info->slot_info[0].bootable = 1
info->slot_info[0].online = 1
info->slot_info[1].bootable = 1
info->slot_info[1].online = 0
info->attemp_times = 12
active slot = 0
cmd: imgread dtb boot_a ${dtb_mem_addr}
[imgread]szTimeStamp[2024071615081273]
[imgread]MTD pageShift 11, writesz 0x800
aml log : R-2048 check pass!
aml log : R2048 check pass!
[imgread]Enc dtb sz 0xe000
Amlogic multi-DTB tool
Single DTB detected
Net: sysnopsys gmac3.7
Phy 0 not found
dwmac.ff3f0000amlkey_init() enter!
amlnf_key_read: ####
amlnf_key_read key data len too much
aml_nand_read_rsv_info:446,read nkey info to 430000
[EFUSE_MSG]keynum is 4
MACADDR:*(from chipid)

Start read misc partition datas!
[burnup]Rd:Up sz 0x440 to align 0x1000
info->attemp_times = 12
info->active_slot = 0
info->slot_info[0].bootable = 1
info->slot_info[0].online = 1
info->slot_info[1].bootable = 1
info->slot_info[1].online = 0
info->attemp_times = 12
active slot = 0
wipe_data=successful
wipe_cache=successful
Setting bus to 2
i2c_set_bus_num i2c sel 2 bus
aml_i2c_init_port init regs for 2
gpio: pin GPIOZ_4 (gpio 18) value is 1
recovery_status=
upgrade_step=2
s_version: U-Boot 2015.01
amlkey_init() enter!
amlkey_init() 71: already init!
[EFUSE_MSG]keynum is 4
[KM]Error:f[key_manage_query_size]L515:key[usid] not programed yet
[KM]Error:f[key_manage_query_size]L515:key[mac] not programed yet
InUsbBurn
noSof

CONFIG_SYSTEM_AS_ROOT: null
system_mode: 0
[imgread]szTimeStamp[2024071615081273]
[imgread]secureKernelImgSz=0x609800
[burnup]Rd:Up sz 0x509800 to align 0x1000
aml log : R-2048 check pass!
aml log : R2048 check pass!
aml log : R2048 check pass!
aml log : R2048 check pass!
avb2: 0
save_power_post ...
avb2: 0
## Booting Android Image at 0x01080000 ...