|
What I mean by reflow method is to flood the BGA with flux, by for example putting the pcb at angle and pouring liquid flux underneath it from the top side until you see it coming from the lower side and then run a complete soldering profile on it without having actually replaced the BGA.
Essentially one is reflowing the existing solder joints in the hope that those defective will form good joints.It works but not always.
| 
Файлы
Прошивки
Продажа
Литература
Статьи
Для просмотра сообщения Вы должны быть Участником форума. Для этого Вам необходимо 
Зарегистрировано всего