::: PWRC_PDN_CTRL=0x42C020, PWRC_PON_STATUS=0x8, PWRC_INT_STATUS=0x0, PWRC_INT_MASK=0x0, PWRC_PIN_STATUS=0x7, PWRC_SC&{{▒k+#K
▒KsK▒Ӧ▒▒▒F▒▒6-▒+&F▒
BootMedia_Init:Boot mode=0x0,real boot mode=0x0

NAND booting

Value=0x0
NAND_Init:Set as SDR NAND
[CheckInterfaceVersion]: binary version = 0x20502
: 00000000000
active info:
block_num=2048, sector_per_block=64, byte_per_sector=2048
physical info:
block_num=2048, sector_per_block=64, byte_per_sector=2048
io info:
block_num=2048, sector_per_block=64, byte_per_sector=2048
chip actived 0x1, chip mode 0xF, chip feature 0x0, chip category 0x10000, reserved_block_percent 0x2
NAND_Init: enable multi-plane chip command
SetChipMode: set chip info succeed
active info:
block_num=2048, sector_per_block=64, byte_per_sector=2048
physical info:
block_num=2048, sector_per_block=64, byte_per_sector=2048
io info:
block_num=2048, sector_per_block=64, byte_per_sector=2048
chip actived 0x1, chip mode 0xF, chip feature 0x0, chip category 0x10000, reserved_block_percent 0x2
NAND_Init: open all zones successfully, total zone number is 2!
zone index (0) mount succeed. logical blk num(64) sec per blk(64)
zone index (1) mount succeed. logical blk num(1924) sec per blk(64)
map size is 123136
NAND_Init: mount all zones successfully, total zone number is 2!

MiscBinSize=0xA00
InitTocGlobalVariable,g_dwMiscBinSize=2560,g_dwMiscDataSize=0
InitTocGlobalVariable,g_dwNKStartSector=8221
+TOC_Setup +
ReadTOCSectors start sector 0x1001 1 sectors, sig 0x434F544E, version 0x2E7D
ReadTOCSectors start sector 0x1002 1 sectors, sig 0x434F544E, version 0x2E7D
Locate 0th TOC successfully
Eboot's vir sector: 0x1,toc sector:0x1
nk's vir sector: 0x201D,toc sector:0x201D
secur's vir sector: 0x1003,toc sector:0x1003

PWRC_PON_STATUS=0x8
RESET_STATUS=0x1

Windows CE Atlas Bootloader Version 3.3 Built Jan 21 2014 19:57:51
UART-UPDATE Flag: 0x6675C8D7
ApkCheckEBOOTSelfDownloadModeFromSD!
BP_Init
mbr blk=0xA1E80800
Sd Update Slot(2)
Image sector starts at physical sector 201D(201D)
BspLcdDispPower...
Is CurNandDsk:1.12
Invalid MBR!!

Launching image from boot media ...
OEMPlatformInit: IMAGE_TYPE_RAMIMAGE|IMAGE_TYPE_BINFS
INFO: Loading image from Boot Media to RAM (address=0x90EFC000, sectors=0x583, launch address=0x90EFD000)...
IsValidMBR: MBR sector = 0x0
Invalid MBR
OpenPartition: Invalid MBR. Cannot open existing partition 0x21.
ERROR: ReadKernelRegionFromBootMedia: Failed to open existing BINFS partition.
OEMPlatformInit ERROR: Failed to load kernel region into RAM.
OEMReportError(-3, 0)