USB VCC: Chip VCC = 1,84
LibUSB ver 3.0.6.0
FileVersion = 0.2.21.35
Using:
1bit bus
Fast timing (24MHz)
Use Fixed Block operation
Using Ignore Errors
eMMC OCR 0xC0FF8080 after 2 attempts
Send CMD1 error!
eMMC (0) CID = 150100384754463452078074464AC5 (0F)
Send CMD2 error!
Found 1 eMMC device(s)
eMMC CSD = D02701320F5903FFF6DBFFEF8E4040
eMMC: Version 4.xx
eMMC: Read Block Length 512 byte
eMMC: Write Block Length 512 byte
eMMC: Card High Capacity
eMMC: CSD User Partition Size = 1073741824 Byte
eMMC: WP Status True
eMMC: WP Size 16 erase groups
eMMC: Permanent WP is False
eMMC: Temorary WP is False
Valid mode SDR 1 bit
SET: Using HS Timing
eMMC: EXT_CSD User Partition Size = 7818182656 Byte
eMMC: Version 5.1
EXTCSD: FW CONFIG = 0x0
EXTCSD: PARTITION CONFIG = 0x48
EXTCSD: BOOT BUS WIDTH = 0x2
eMMC: Erase Group Size = 512 KByte (1024 blocks)
eMMC: Boot partition size 4194304 byte
eMMC: RPMB partition size 524288 byte
RPMB: Use correct key to read/write! (4513)
eMMC MID = 0x0015, OEM ID = 0x0001
eMMC Product Name = 8GTF4R
eMMC Name = KLM8G1GETF-B041
eMMC Serial number = 0x8074464A
eMMC Revision = 0.7
eMMC Date 12/2002

Используем все разделы eMMC
Читаем раздел User в файл C:\tinitool\emmc\Dumps\nu8500\old.user
Чтение начато
11:38:41
Читаем раздел Boot1 в файл C:\tinitool\emmc\Dumps\nu8500\old.boot1
Чтение начато
12:19:09
Читаем раздел Boot2 в файл C:\tinitool\emmc\Dumps\nu8500\old.boot2
Чтение начато
12:19:11
RPMB пропускаем ..
Чтение завершено